Republic Relay Product Information:
Please review the product information, health and safety information and instructions at https://relaygo.com before using your device. You can also find a link to the limited warranty, regulatory information and additional support resources from there.
Electronic Shock and Heat:
Do not expose Republic Relay or its power charger to water or extreme conditions. Handle with care to avoid electric shock when using the power charger. Only use the provided power charger to charge the Republic Relay unit. If your Republic Relay unit power charger or unit is hot to the touch, please unplug the Republic Relay and the power charger and let it cool.
Pacemakers and Other Implanted Devices:
Republic Relay contains magnets and components that emit an electromagnetic field and could interfere with pacemakers or other electronic medical devices. Before using your Republic Relay, consult with your doctor or medical device manufacturer about the required safe distance between Republic Relay and your medical device.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.
FCC RF Exposure Information (SAR)
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States.
During SAR testing, this device is set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage near the body with the separation of 10 mm. To reduce exposure to RF energy, use the hands-free option with the built-in speakerphone, or an optional set of headphones, or other similar accessories. Although the SAR is determined at the highest certified power level, the actual SAR level of the while operating can be well below the maximum value. This is because the device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: 2AMBHRW2265.
The exposure standard for wireless employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification is Head - 0.81 W/Kg and Body - 1.19 W/Kg.